Turntable Rotation Components; Turntable Rotation Assembly - Genie S-40 Service Manual

Section 4 • Repair Procedures

Turntable Rotation Components

8-1

Turntable Rotation Assembly

How to Remove the Turntable
Rotation Assembly
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose end must be
replaced and then torqued to specification during
installation.
Refer to Section 2, Hydraulic Hose and Fitting
Torque Specifications.
Note: Perform this procedure with the machine on a
firm and level surface.
1 Secure the turntable from rotating with the
turntable rotation lock pin.
Unlocked position
Locked position
4 - 50
2 Tag, disconnect and plug the hydraulic hoses
3 Attach a suitable lifting device to the turntable
f
e
S-40 • S-45 • S-40 TRAX • S-45 TRAX
from the motor, brake and manifold. Cap the
fittings on the motor, brake and manifold.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not
allow oil to squirt or spray.
rotator assembly.
d c
a brake assembly
b drive hub
c backlash plate mounting bolts
d backlash plate
e manifold
f motor
February 2014
b
a
Part No. 826364