Panel Cradle Assembly; Installation Of Padding; Panel Cradle Installation; Installation Of Strap - Genie Z-135/70 Operator's Manual

Operator's Manual
Operating Instructions

Panel Cradle Assembly

1 Apply the warning decal to the front of each
panel cradle (if needed).
2 Install rubber bumper 1 in the panel cradle base.
See the illustration.
3 Secure the bumper with 2 high profile lock nuts
and 2 washers.

Panel Cradle Installation

1 Insert the hook piece through the slots in the
panel cradle base.
2 Hook the panel cradle to the bottom platform
tube in the desired location.
3 Install rubber bumper 2 through the panel cradle
base and the hook piece. See the illustration.
4 Secure with 2 low profile lock nuts.
5 If the panel cradle is installed at a platform floor
support tube, insert the U-bolt through the floor,
around the tube and into the panel cradle base.
6 Secure the U-bolt with 2 nuts and 2 washers.
Proceed to step 9.
7 If the panel cradle is not installed at a platform
floor support tube, use the aluminum tube
provided.
8 Place the tube between the panel cradle and the
platform floor. Insert the U-bolt through the floor,
around the tube and into the panel cradle base.
9 Repeat above for the second set of parts.
56

Installation of Padding

1 Install the 2 pieces of padding on the platform
rails. Position the padding to protect the panels
from contact with the platform rails.

Installation of Strap

1 Open the clamp and install it around a vertical
platform rail tube.
2 Insert a bolt with a washer through one side of
the clamp.
3 Install the strap assembly end plate onto the
bolt.
4 Insert the bolt through the other side of the
clamp.
5 Secure with a washer and a nut. Do not over-
tighten. The strap assembly end plate should be
able to slide on the platform rail.
Z-135/70
Second Edition · Fourth Printing
Part No. 114474