How To Install The Pump And Bell Housing Assembly - Genie Z-80/60 Service And Repair Manual

September 2016
How to i nstall the Pump and Bell H ousing Ass embl y
How to Install the Pump and Bell
Housing Assembly
1 Install the pump and bell housing assembly.
Deutz models: Torque the bell housing
mounting bolts labeled "C" in sequence to
28 ft-lbs / 38 Nm. Then torque the bell housing
mounting bolts labeled "C" in sequence to
40 ft-lbs / 54 Nm.
Perkins 804D models: Torque the bell
housing mounting bolts in sequence to
28 ft-lbs / 38 Nm and then to 49 ft-lbs / 66 Nm.
Perkins 404F models:Torque the bell
housing mounting bolts labeled "B" in
sequence to 28 ft-lbs / 38 Nm and the
mounting bolts labeled "A" to 49 ft-lbs / 66 Nm.
Then torque the bell housing mounting bolts
labeled "B" in sequence to 40 ft-lbs / 54 Nm
and the mounting bolts labeled "A" to 70 ft-lbs /
95 Nm.
Continental model:Torque the pump
mounting plate fasteners in sequence to
23 ft-lbs / 31.2 Nm.
Component damage hazard.
When installing the pump, do not
force the pump coupler into the
flexplate or damage to the pump
shaft seal may occur.
Component damage hazard. Do
not force the drive pump during
installation or the flex plate teeth
may become damaged.
Part No. 1268556
Service and Repair Manual
Deutz Pump Mounting Plate
Perkins 804D Pump Mounting Plate
Perkins 404F-22T Pump Mounting Plate
Continental Pump Mounting Plate
Engines
63