Chrysler Concorde 2004 Service Manual page 1204

TRANSMISSION - NGC
P0706-CHECK SHIFTER SIGNAL —
TEST
4 Turn the ignition off to the lock position.
Remove the Starter Relay.
CAUTION: Removal of the Starter Relay is to prevent a Transmission, NO
RESPONSE, condition and disable the starter.
Install the Transmission Simulator, Miller tool #8333 and the Electronic Transmis-
sion Adapter kit 8333-1A.
Ignition on, engine not running.
With the DRBIII , perform the Shift Lever Position Test.
When the DRBIII
you must do so using the Transmission Simulator.
The LED for the gear position in question must be illuminated on the Transmission
Simulator, prior to pressing the ENTER key on the DRBIII .
Did the Shift Lever Position Test pass?
Yes → Go To 5
No
NOTE: After completion of this procedure, make sure to disconnect the
Transmission Simulator, Miller tool #8333 and FWD adaptor cable kit, Miller
tool #8333-1A and reconnect all connectors.
5 If there are no possible causes remaining, view repair.
Repair
6 Ignition on, engine not running.
With the DRBIII , monitor the TRS Sense circuits on the Input/Output screen - C1
thru C4.
Move the shift lever through all gear positions, pausing momentarily in each gear
position and watch for one of the circuits to not change state.
Pick the one that did not change state.
TRS T1 sense (C4)
TRS T3 sense (C3)
TRS T41 sense (C1)
TRS T42 sense (C2)
ACTION
instructs you to put the Gear Selector in a particular position,
→ Go To 6
Replace the Transmission Range Sensor per the Service Informa-
tion.
Perform 42LE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
Go To 7
Go To 10
Go To 13
Go To 16
Continued
44
APPLICABILITY
All
All
All