Utility Package (Gx Configurator-Da); Utility Package Functions - Mitsubishi MELSEC-Q series User Manual

5

UTILITY PACKAGE (GX Configurator-DA)

5 UTILITY PACKAGE (GX Configurator-DA)
5.1

Utility Package Functions

Table 5.1 shows an overview of the utility package functions.
Item
(1) Set the following items that require initial setting.
* 1
Initial setting
(2) The data for which initial setting has been completed is registered in the
(1) Sets automatic refresh for the Q66DA-G buffer memory.
Automatic refresh
(2) The buffer memory that was set for automatic refresh is automatically read
* 1
setting
(1) Monitor/Test
(2) Operating condition setting
(3) Offset/gain setting
Monitor/Test
(4) Pass data
Generates FB automatically from the intelligent function module parameter
FB conversion
(initial setting/auto refresh setting).
5
- 1 5.1 Utility Package Functions
Table5.1 Utility package (GX Configurator-DA) function list
Reference section
• D/A conversion enable/disable setting
• Scaling enable/disable setting
• Scaling upper limit value/lower limit value
• Rate control enable/disable setting
• Increase/decrease digital limit values
• Disconnection detection setting
• Warning output setting
• Warning output upper limit value/lower limit value
parameters for the programmable controller CPU, and automatically writ-
ten to the Q66DA-G when the programmable controller CPU changes to
RUN status.
and written to the specified device when the END command for the pro-
grammable controller CPU is executed.
The buffer memory and I/O signals for the Q66DA-G are monitored and
tested.
Changes the D/A conversion enable/disable during operation.
When setting the offset/gain to a value selected by the user (when the
analog output range setting is user range setting), the offset and gain can
be easily set while viewing the screen.
The pass data (pass data classification setting, industrial shipment set-
tings offset/gain values, user range settings offset/gain values) can be
monitored and set.
Description
Section 5.4
Section 5.5
Section 5.6
Section 5.7