Mitsubishi MELSEC-Q series User Manual page 16

1
OVERVIEW
(7) Warning output function
(8) Rate control function
(9) Scaling function
(10)Online module change
(11)Offset/gain setting
(12)Easy settings using the utility package
1
- 2 1.1 Features
A warning is output if a digital input value falls outside the setting range. (Refer to
Section 3.2.4.)
The increase and decrease in analog output values per 6ms *1 can be limited,
preventing rapid change of the values. (Refer to Section 3.2.4.)
*1 6ms is the conversion cycle per channel.
The digital input value range can be changed to any given range between –32000 and
32000, and digital values within the range are converted to analog values. (Refer to
Section 3.2.5.)
The module can be changed without the system being stopped.
Further, the dedicated instruction (G(P). OGLOAD, G(P). OGSTOR), write to the
buffer memory, or turning ON the Y signal enables "inheritance of offset/gain settings
to the new Q66DA-G replacing the old one changed online" and "transfer of offset/
gain settings to the other Q66DA-G mounted on the other slot". (These apply to the
modules of the same model.) (Refer to Chapter 7.)
GX Configurator-DA, dedicated instruction (G(P). OFFGAN) or mode switching
setting allows a shift to the offset/gain setting mode easily. (Refer to Section 4.6.)
A utility package is sold separately (GX Configurator-DA).
The utility package is not a required item, however, it is useful for on-screen setting of
the intelligent function module parameters (initial setting/auto refresh setting). In
*1
addition, FB can be generated automatically from the intelligent function module
parameters that have been set up and used in a sequence program. (Refer to
Chapter 5.)
*1: FB is the function for making a circuit block used in a sequence program repeatedly a part (FB) to
use it in the sequence program.
This function can improve the efficiency of program development and minimize program bugs to
improve program qualities.
For the details of FB, refer to "GX Developer Version 8 Operating Manual (Function Block)."