Mitsubishi MELSEC-Q series User Manual page 97

5
UTILITY PACKAGE (GX Configurator-DA)
[Explanation of items]
(1) Items
(2) Command buttons
Remark
Setting item : Displays buffer memory names.
Current value : Monitors the present buffer memory values.
Setting value : Enter or select values to be written into the buffer memory
for test operation.
/
(1) Turning the output enable/disable flag ON/OFF or writing the CH
value during test operation changes the analog output, so perform these after
taking ample safety precautions.
The selection test operation is explained below using the CH1 digital value writing
as an example.
(1) Change the setting value field for "Y01: CH1 output enable/disable flag" to
"ON: enable."
Nothing is written to the Q66DA-G at this point.
(2) Click and select the setting value field to be written in the Q66DA-G.
To write more than one setting item at the same time, select the items while
holding down the
(3) Click the Execute test to execute the write operation.
Once writing has been completed, the value that was written will be displayed
in the present value field.
Displays the current value of the item selected.
(This is used to check the text that cannot be dis-
played in the current value field. However, in this
utility package, all items can be displayed in the
display fields.)
Creates a file containing the screen data in text
file format.
Selects whether or not to monitor current values.
Performs a test on the selected items. To select
more than one item, select them while holding down
the key.
Closes the currently open screen and returns to
the previous screen.
key.
5.6 Monitoring/Test
5.6.1 Monitor/test screen
1
2
3
4
5
digital
6
7
8
5
- 22