Utility Package (Gx Configurator-Da); Utility Package Functions - Mitsubishi Q62DA User Manual

5 UTILITY PACKAGE (GX Configurator-DA)

5 UTILITY PACKAGE (GX Configurator-DA)

5.1 Utility Package Functions

Table 5.1 shows an overview of the utility package functions.
Table 5.1 Utility package (GX Configurator-DA) function list
Item
1
Initial Setting
Automatic Refresh Setting
1
Monitor/test
5 - 1
(1) Sets the D/A conversion enable/disable.
(2) The data for which initial setting has been completed is registered in
the parameters for the PLC CPU, and automatically written to the
D/A conversion module when the PLC CPU changes to RUN
status.
(1) Sets automatic refresh for the D/A conversion module buffer
memory.
(2) The buffer memory that was set for automatic refresh is
automatically read and written to the specified device when the
END command for the PLC CPU is executed.
(1) Monitor/test
The buffer memory and I/O signals for the D/A conversion modules
are monitored and tested.
(2) Operating condition setting
Changes the D/A conversion enable/disable during operation.
(3) Offset/gain setting
When setting the offset/gain to a value selected by the user (when
the analog output range setting is user range setting), the offset and
gain can be easily set while viewing the screen.
POINT
1 If initial setting and automatic refresh setting are performed, the intelligent
function module parameters require a maximum of 24 bytes per module.
Description
MELSEC-Q
Reference section
Section 5.4
Section 5.5
5
Section 5.6
5 - 1