Online Module Change Procedure; When Industrial Shipment Setting Is Used And Initial Setting Was Made With Gx Configurator-Da - Mitsubishi MELSEC-Q series User Manual

7
ONLINE MODULE CHANGE
7.3

Online Module Change Procedure

There are the following online module change procedures depending on whether the user
range setting has been made or not, whether the initial setting of GX Configurator-DA has
been made or not, and whether the other system exists or not.
7.3.1 When industrial shipment setting is used and initial setting was
made with GX Configurator-DA
(1) Conversion disable
(a) Set D/A Conversion enable/disable setting (Un\G0) for all channel conversion

7.3.1 When industrial shipment setting is used and initial setting was made with GX Configurator-DA

Range setting
Industrial shipment setting GX Configurator-DA
Industrial shipment setting
User range setting GX Configurator-DA
User range setting GX Configurator-DA
User range setting
User range setting
disable and turn Operating condition setting request (Y9) from OFF to ON to stop
conversion.
After confirming that conversion has stopped with the actual analog output value,
turn OFF Operating condition setting request (Y9).
Initial setting Other system
Sequence program
Present
Absent
Sequence program Present
Sequence program Absent
7.3 Online Module Change Procedure
Reference section
— Section 7.3.1
— Section 7.3.2
Section 7.3.3
Section 7.3.4
Section 7.3.5
Section 7.3.6
7
1
2
3
4
5
6
7
8
- 4