Mitsubishi MELSEC-Q series User Manual page 113

6
PROGRAMMING
(2) Intelligent function module switch setting
Based on the setting conditions given in Section6.2 (2), make the intelligent function
module switch settings.
(a) Each switch setting
(b) Write the settings in (a) to the Q66DA-G.
1) Switch1,Switch2: output range setting
<Switch 2> <Switch 1>
0 0 0 0 0 0 3
H
CH6 CH5 CH4 CH3 CH2 CH1
0:Fixed
2) Switch3: HOLD/CLEAR setting function
<Switch 3>
0 0 0 0
H
b15 b6 b5 b4 b3 b2 b2 b2 b1 b1 b1
0 0 0 0 0 0 0
CH6 CH5 CH4 CH3 CH2
0:Fixed
3) Switch4: Mode setting
<Switch 4>
0 F 0 0
H
0:Fixed
4) Switch5: Use prohibited (0:fixed)
<Switch 5>
0 0 0 0
H
* If any other than 0 is set to Switch 5, an error occurs.
On GX Developer's "Parameter setting" screen, select the "I/O assignment" tab,
click "Switch setting", and make settings of Switch 1 to 5 on the screen shown
below.
6.2 For Use in Normal System Configuration
0
H
CH1 :0 (4 to 20mA output)
H
CH2 :3 (0 to 5V output)
H
CH3 to CH6 :0 (Default)
H
b0
0
CH1
CH1 :0 (CLEAR)
CH2 :0 (CLEAR)
CH3 to CH6 :0 (Dfault)
Setting of normal resolution mode / high resolution mode
All Channels: F (high resolution mode)
H
Setting of normal mode / offset/gain setting mode
All Channels: F (normal mode)
H
0:Fixed
6.2.1 Before creating a program
1
2
3
4
5
6
7
8
6
- 4