7
ONLINE MODULE CHANGE
7
7.3 Online Module Change Procedure
- 15
7.3.3 When user range setting is used and initial setting was made with GX Configurator-DA (other system
(b) Click the "Execution" button to enable a module change.
If the following error screen appears, the user range cannot be saved.
Click the [OK] button, and perform the operation in Section 7.3.4 (2) (c) and later.
(c)
After confirming that the "RUN" LED of the module has turned off, remove the
connector and dismount the module.
Always dismount the module. If mounting confirmation is made without the mod-
ule being dismounted, the module will not start properly and the "RUN" LED will
not be lit.