Chapter 5 Utility Package (Gx Configurator-Ti); Utility Package Functions - Mitsubishi Q68TD-G-H01 User Manual

5
UTILITY PACKAGE (GX Configurator-TI)

CHAPTER 5 UTILITY PACKAGE (GX Configurator-TI)

5.1

Utility Package Functions

Table 5.1 shows a list of the utility package functions.
Function
(1) Make initial setting for operating the Q68TD-G-H02(H01) channel-by-channel.
Set the values of the items which require initial setting.
•Conversion enable/disable setting
•Averaging processing selection
•Time/count/moving average/time constant setting
•Warning output enable/disable setting (Process alarm)
•Thermocouple type
•Process alarm lower lower limit value
Initial
•Process alarm lower upper limit value
setting
•Process alarm upper lower limit value
•Process alarm upper upper limit value
•Warning output enable/disable setting (Rate alarm)
•Rate alarm warning detection period
•Rate alarm upper limit value
(2) The data for which initial setting has been completed is registered in the parameters for the programmable
controller CPU, and automatically written to the Q68TD-G-H02(H01) when the programmable controller CPU
changes to the RUN status.
(1) Set the automatically refreshed Q68TD-G-H02(H01) buffer memory channel-by-channel.
•Conversion completion flag
•CH Measured temperature value
Automatic
refresh •Error code
setting
•Setting range
(2) The values stored in the Q68TD-G-H02(H01) buffer memory where automatic refresh setting was made are
automatically read or writhen when the END instruction of the programmable controller CPU is executed.
Table 5.1 Utility Package (GX Configurator-TI) Function List
Description
•Warning output flag
•Disconnection detection flag (Disconnection state monitor
flag)
•CH
•Rate alarm lower limit value
•Scaling range lower limit value
•Scaling range upper limit value
•Scaling valid/invalid setting
•Scaling width lower limit value
•Scaling width upper limit value
•Conversion setting for disconnection detection
(Disconnection state conversion setting)
•Conversion setting value for disconnection
detection (Conversion setting for disconnection
*1
state value)
*1
Scaling value
5.1 Utility Package Functions
1
2
Reference
section
3
Section 5.4
*1
4
5
Section 5.5
6
7
8
5
- 1