Mitsubishi MELSEC-Q series User Manual page 122

6
PROGRAMMING
(2) Operating the utility package
6
- 13 6.3 For Use on Remote I/O Network
6.3.1 Program example using the utility package
(a) Initial setting (Refer to Section 5.4)
CH1, CH2 D/A conversion enable/disable setting..... "Enable"
CH1 rate control enable/disable setting .................... "Enable"
CH1 increase digital limit value ................................. "100"
CH1 decrease digital limit value ................................ "30"
CH2 warning output setting....................................... "Enable"
CH2 warning output upper limit value ....................... "10000"
CH2 warning output lower limit value........................ "3000"
(b) Auto refresh setting (Refer to Section 5.5)
CH1, CH2 digital values ............................................ W11, W12
Warning output .......................................................... W116
Error code ................................................................. W117
(c) Write of intelligent function module parameters (Refer to Section 5.3.3)
The intelligent function module parameters are written to the remote I/O station.
Perform this operation on the parameter setting module selection screen.