For Use In Normal System Configuration - Mitsubishi MELSEC-Q series User Manual

6
PROGRAMMING
6.2

For Use in Normal System Configuration

(1) System configuration
(2) Conditions for the intelligent function module switch setting
Input range setting
CH1 4 to 20mA
CH2 0 to 5V
CH3
to not used
CH6
(3) Program conditions
(a) CH1 uses the rate control function (Refer to Section 3.2.4.)
(b) CH2 uses the warning output function (Refer to Section 3.2.4.)
(c) If an error occurs in writing a digital value, an error code is displayed in binary
QX10 (X/Y10 to X/Y1F)
QY10 (X/Y20 to X/Y2F)
Q66DA-G
(X/Y0 to X/YF)
HOLD/CLEAR function setting
CLEAR
-
• CH1 increase digital limit value: 100
• CH1 decrease digital limit value: 30
• CH2 warning output upper limit value: 10000
• CH2 warning output lower limit value: 3000
If a warning is output, the warning output flag status is read and processing for the
warning output is performed.
coded decimal (BCD) form.
The error code shall be reset after removal of the cause.
CH1: 4 to 20mA output
CH2: 0 to 5V output
Normal resolution mode/ High resolution mode
6.2 For Use in Normal System Configuration
High resolution mode
-
6
1
2
3
4
5
6
7
8
- 2