Mitsubishi MELSEC-Q series User Manual page 149

7
ONLINE MODULE CHANGE
(3) Mounting of new module
(4) Operation check
7.3.4 When user range setting is used and initial setting was made with GX Configurator-DA (other system
(a) Mount a new module to the same slot and install the connector.
(b) After mounting the module, click the [Execution] button and make sure that the
"RUN" LED is lit. Module Ready (X0) remains OFF.
(a) To make an operation check, click the [Cancel] button to cancel control
resumption.
(b) Click the [OK] button to leave the "Online module change" mode.
7.3 Online Module Change Procedure
1
2
3
4
5
6
7
8
7
- 22