Mitsubishi MELSEC-Q series User Manual page 133

7
ONLINE MODULE CHANGE
(c) After confirming that the "RUN" LED of the module has turned off, remove the
(3) Mounting of new module
(a) Mount a new module to the same slot and install the connector.
(b) After mounting the module, click the [Execution] button and make sure that the
(4) Operation check
(a) To make an operation check, click the [Cancel] button to cancel control
7.3.1 When industrial shipment setting is used and initial setting was made with GX Configurator-DA
connector and dismount the module.
Always dismount the module. If mounting confirmation is made without the mod-
ule being dismounted, the module will not start properly and the "RUN" LED will
not be lit.
"RUN" LED is lit. Module Ready (X0) remains OFF.
resumption.
7.3 Online Module Change Procedure
1
2
3
4
5
6
7
8
7
- 6