Mitsubishi MELSEC-Q series User Manual page 82

5
UTILITY PACKAGE (GX Configurator-DA)
(2) Data created with the utility package
5
- 7 5.3 Utility Package Operation
5.3.1 Common utility package operations
The following data or files that are created with the utility package can be also han-
dled in GX Developer. Figure 5.1 shows respective data or files are handled in which
operation.
<Intelligent function module parameter>
(a) This represents the data created in Auto refresh setting, and they are stored in an
intelligent function module parameter file in a project created by GX Developer.
Project
Program
Parameter
PLC parameter
Network parameter
Intelligent function module parameter
(b) Steps 1) to 3) shown in Figure 5.1 are performed as follows:
1) From GX Developer, select:
[Project] [Open project] / [Save]/ [Save as]
2) On the intelligent function module selection screen of the utility, select:
[Intelligent function module parameter]
ters]
3) From GX Developer, select:
[Online] [Read from PLC] / [Write to PLC] "Intelligent function module
parameters"
Alternatively, from the intelligent function module selection screen of the utility,
select:
[Online] [Read from PLC] / [Write to PLC]
[Open parameters] / [Save parame-