Mitsubishi MELSEC-Q series User Manual page 45

3
SPECIFICATIONS
Device No. Signal name
Operating condition
X9 setting completed
flag
Offset/gain setting
XA
mode flag
(1) This is used as an interlock condition for turning ON/OFF the operating condition setting
request (Y9) when any of the following settings is changed.
D/A conversion enable/disable setting (Un\G0)
Rate control enable/disable setting (Un\G46)
Warning output setting (Un\G47)
Scaling enable/disable setting (Un\G53)
Scaling upper/lower limit value (Un\G54 to Un\G65)
Increase/decrease digital limit value (Un\G70 to Un\G81)
Warning output upper/lower limit value (Un\G86 to Un\G97)
(2) Under the following conditions, the operating condition setting completed flag (X9) turns OFF.
When operating condition setting request (Y9) is ON
Module READY(X0)
Operating condition
setting completed flag(X9)
Operating codition
setting request(Y9)
[In offset/gain setting mode]
(1) This is used as an interlock condition for turning ON/OFF the user range write request (YA)
when registering the value after adjustment of the offset/gain settings have been completed.
(2) Refer to Section 4.6 regarding the offset/gain settings.
Module READY(X0)
Offset/gain setting mode flag (XA)
User range write request (YA)
[In normal mode]
(1) This is used as an interlock condition to turn ON/OFF the User range write request (YA) when
the user range is restored.
(2) Refer to Chapter 7 regarding the user range restoration.
Module READY(X0)
Offset/gain setting mode flag (XA)
User range write request (YA)
3.3 I/O Signals for the Programmable Controller CPU
Description
Performed by the Q66DA-G
Performed by the sequence program
Performed by the Q66DA-G
Performed by the sequence program
OFF
Performed by the Q66DA-G
Performed by the sequence program
ON
3.3.2 Details of I/O signals
1
2
3
4
5
6
7
8
3
- 23