Mitsubishi MELSEC-Q series User Manual page 73

4
SETUP AND PROCEDURES BEFORE OPERATION
(2) Program examples
The program in the dotted area of (a) is common to (a), (b) and (c).
In this example, the I/O signals for the Q66DA-G are X/Y0 to X/YF.
• Channel selection..................................................................................... M0
• Offset/gain range setting .......................................................................... M1
• Offset setting ........................................................................................... M2
• Gain setting ............................................................................................. M3
• Channel change command ..................................................................... M4
• Writing the adjustment amount ............................................................... M5
• Analog output value adjust command ..................................................... M6
• Offset/gain setting value write command to the module .......................... M7
• Mode switching ........................................................................................ M8
• Normal mode checking signal .................................................................. M50
• Channel designation storage device ........................................................ D0
• Dedicated instruction (G(P).OFFGAN) setting storage device ................. D2
• Offset/gain adjustment storage device ..................................................... D1
4.6 Offset/Gain Settings
1
2
3
4
5
6
7
8
4
- 13