Automatic Redial - Comdial DXP Attendant Manual

Digital communications system impact and impact scs lcd speakerphones
Hide thumbs Also See for DXP:
Table of Contents

Advertisement

Other Features

Automatic Redial

With this feature, the system automatically redials a busy or unanswered outside
call. Once you activate automatic redial, the station selects the line, automati-
cally dials the number, and waits for a response. (It dials and then waits 30
seconds for an answer.) If the called station does not answer, the redialing station
disconnects, waits one minute, and then repeats the sequence. The station will
repeat this procedure for approximately 10 minutes.
The feature cycle is timed and does not have busy and ring-no-answer detection
circuitry. Because of this, if you are operating handsfree when the called party
answers, you must take the handset off-hook to prevent being cut off by the
timing cycle.
You must program an AUTOMATIC REDIAL button at one of the designated
programmable button locations on their telephones before you can use it. See the
instructions on page 64 to program an AUTOMATIC REDIAL button.
To use the automatic redial feature to redial a busy or
unanswered number,
1. While on the call, SELECT ARDL OR PRESS
the AUTOMATIC REDIAL button programmed
by your installer.
2. The system repeatedly dials the number until
you cancel the feature or the system has dialed
the number a preprogrammed number of times
(determined by your system installer).
3. The AUTOMATIC REDIAL light flashes be-
tween redials and turns on steady during
redialing.
4. IF your installer has enabled answer supervision on your line, the
system automatically cancels automatic redialing and turns the
AUTOMATIC REDIAL light off.
5. IF answer supervision is NOT enabled, SELECT ARDL OR the
programmed AUTOMATIC REDIAL button while on the call to
cancel automatic redialing,
The enhanced automatic dialing feature adds a multiple redial feature. When
installers enable this option, the station can have multiple numbers queued for
ARD (automatic redial). When you enable multiple ARD, a station can store up
to the last 10 numbers the user dials.
70
GCA70-250
L123
CONF
ARDL
Initiating Autoredial
Attendant Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxp plusFxtFxs

Table of Contents