Response Message Button - Comdial DXP Attendant Manual

GCA70-250

Response Message Button

You may program a RESPONSE MESSAGE button, which allows you to send
an LCD message to a caller who has initiated a SOHVA or intercom call from an-
other LCD speakerphone, or to send an LCD message to another LCD
speakerphone that you call and receive a busy signal or no answer.
To store a scrolling RESPONSE MESSAGE button, proceed
•
as follows (user may press button repeatedly to choose
from up to 30 system supplied messages),
1. PRESS INTERCOM.
2. DIAL
3. PRESS programmable button for RESPONSE MESSAGE button
location.
4. DIAL
5. DIAL
6. PRESS SPEAKER to end.
7. LABEL button location.
To store a fixed RESPONSE MESSAGE button (delivers the
•
same message each time it is pressed),
1. PRESS INTERCOM.
2. DIAL
3. PRESS programmable button for RESPONSE MESSAGE button
location.
4. DIAL message number (01-30) from list of messages.
NOTE: Programmed messages available for use are created by the system
attendant and listed in a table on page 55.
5. DIAL
6. PRESS SPEAKER to end.
7. LABEL button location.
Attendant Manual
**6
.
00
.
#
to save programming.
**6
.
#
to save programming.
Programming
67