Installing the MX2020 Upper Cable Manager
Copyright © 2015, Juniper Networks, Inc.
Figure 194: Installing the Standard Lower Cable Manager
NOTE:
To accommodate additional clearance, you may order an extended
upper cable manager from Juniper Networks.
To install the upper cable manager (see
Position the upper cable manager on the studs on the upper front of the chassis, just
1.
below the craft interface.
Insert the screws into the corners in the upper cable manager onto the studs on the
2.
chassis.
Using a Phillips (+) screwdriver (number 1 or 2), tighten the mounting screws securely.
3.
Replace the cable manager cover, and secure the two captive screws.
4.
Chapter 25: Replacing Components
Figure 170 on page
333):
441