Installing An Sfp Or Xfp Transceiver Into An Mx2020 Mpc Or Mic; Figure 237: Removing Sfps Or Xfps - Juniper MX2020 Hardware Manual

Installing an SFP or XFP Transceiver into an MX2020 MPC or MIC

Copyright © 2015, Juniper Networks, Inc.
Using your fingers, grasp the body of the transceiver, and pull it the rest of the way
8.
out of the MPC or MIC.

Figure 237: Removing SFPs or XFPs

Place a rubber safety cap over the transceiver.
9.
Place the removed transceiver on an antistatic mat or in an electrostatic bag.
10.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
To install an SFP or XFP:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Carefully align the transceiver with the slots in the component. The connectors should
4.
face the component.
Slide the transceiver until the connector is seated in the component slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
6.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
7.
the cable into the transceiver.
Chapter 25: Replacing Components
503