Preventing Electrostatic Discharge Damage To An Mx2020 Router; Figure 251: Placing A Component Into An Electrostatic Bag - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation

Preventing Electrostatic Discharge Damage to an MX2020 Router

558
Installation Safety Warnings for Juniper Networks Devices on page 563
Maintenance and Operational Safety Warnings for Juniper Networks Devices on page 573
General Electrical Safety Warnings for Juniper Networks Devices on page 579
DC Power Electrical Safety Warnings for Juniper Networks Devices on page 586
Many router hardware components are sensitive to damage from static electricity. Some
components can be impaired by voltages as low as 30 V. You can easily generate
potentially damaging static voltages whenever you handle plastic or foam packing
material or if you move components across plastic or carpets. Observe the following
guidelines to minimize the potential for electrostatic discharge (ESD) damage, which
can cause intermittent or complete component failures:
Always use an ESD wrist strap or ankle strap, and make sure that it is in direct contact
with your skin.
CAUTION: For safety, periodically check the resistance value of the ESD
strap. The measurement should be in the range of 1 through 10 Mohms.
When handling any component that is removed from the chassis, make sure the
equipment end of your ESD strap is attached to one of the ESD points on the chassis.
Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can still damage components.
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag (see
Figure 251 on page 558) . If you are returning a component, place it in an electrostatic
bag before packing it.

Figure 251: Placing a Component into an Electrostatic Bag

Copyright © 2015, Juniper Networks, Inc.