Figure 218: Installing The Extended Emi Cover Mounting Brackets - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
470
For the lower extended EMI card cover, the groove that holds the points on the cover
should be at the bottom.
Secure the extended EMI cover mounting brackets using the four screws provided
3.
(two on each side) (see

Figure 218: Installing the Extended EMI Cover Mounting Brackets

0
Orient the cover so that the arrows point up in front of the card cage.
4.
Angle the cover so that the points each side of the extended EMI cover fit into the
5.
grooves on the EMI cover mounting brackets.
Tilt the extended EMI cover into place and press firmly until the sides contact the EMI
6.
cover mounting brackets:
The upper extended EMI cover tilts from the top.
Figure 157 on page 310).
Copyright © 2015, Juniper Networks, Inc.