Installing an MX2020 Dual-Wide MIC
Copyright © 2015, Juniper Networks, Inc.
Figure 228: Installing a MIC
0
To install a dual-wide MIC:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the septum, if necessary (see
2.
Place the MPC on a flat surface. If necessary, remove the MPC from the ADC as
a.
described in
"Removing an MX2020 MPC from the Adapter Card" on page
Remove the four screws labeled
b.
Remove the two screws labeled
c.
Slide the septum toward you and out of the MPC.
d.
Store the septum and screws for later use.
e.
Install the MPC as described in
f.
on page
492.
19
Figure 155 on page
on the bottom of the MPC.
S
on the top of the MPC.
S
"Installing an MX2020 MPC into an Adapter Card"
Chapter 25: Replacing Components
307):
487.
481