Replacing The Mx2020 Extended Emi Covers; Removing The Mx2020 Extended Emi Covers; Figure 215: Installing The Standard Emi Card Cage Cover - Juniper MX2020 Hardware Manual

Related
Documentation

Replacing the MX2020 Extended EMI Covers

Removing the MX2020 Extended EMI Covers

Copyright © 2015, Juniper Networks, Inc.

Figure 215: Installing the Standard EMI Card Cage Cover

0
10
11
12
13
14
15
16
17
18
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 558
Replacing the MX2020 Extended EMI Covers on page 467
Removing the MX2020 Extended EMI Covers on page 467
Installing the MX2020 Extended EMI Cover on page 469
Two extended electromagnetic interference (EMI) covers attach to the router over the
upper and lower card cages.
To remove the extended electromagnetic interference (EMI) card cage cover (see
Figure 216 on page 468):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Gripping the flap on the extended EMI cover, tilt it away from the router toward you:
2.
The upper extended EMI cover tilts from the top.
The lower extended EMI cover tilts from the bottom.
Holding the cover on both sides, lift so that the points on the cover come out of the
3.
grooves on the EMI cover brackets.
Chapter 25: Replacing Components
467