Load Factory Default; Save Configuration; Figure 95 Load Factory Default: Start - ZyXEL Communications ES-2724 User Manual

ES-2724 User's Guide
Table 67 Maintenance (continued)
LABEL
Save
Configuration
Reboot
System

29.2 Load Factory Default

Follow the steps below to reset the switch back to the factory defaults.
1 In the Maintenance screen, click the Click Here button next to Load Factory Default to
clear all switch configuration information you configured and return to the factory
defaults.
2 Click OK to reset all switch configurations to the factory defaults.

Figure 95 Load Factory Default: Start

3 In the web configurator, click the Save button to make the changes take effect. If you
want to access the switch web configurator again, you may need to change the IP address
of your computer to be in the same subnet as that of the default switch IP address
(192.168.1.1).

29.3 Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on
the switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration
changes to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the switch.
190
DESCRIPTION
Click Config 1 to save the current configuration settings to Configuration 1 on the
switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the
switch.
Click Config 1 to reboot the system and load Configuration 1 on the switch.
Click Config 2 to reboot the system and load Configuration 2 on the switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the switch.
Chapter 29 Maintenance