Lldp-Med Configuration - ZyXEL Communications GS2220 Series User Manual

Table 168 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting (continued)
L ABEL
Power Via MDI
Apply
Cancel
36.7 L L DP- MED C o nfig ura tio n
Click
Adva nc e d Applic a tio n
Fig ure 254
The following table describes the labels in this screen.
Table 169 Advanced Application > LLDP > LLDP-MED Configuration
L ABEL
Port
*
Notification
Topology
Change
Chapter 36 Link Layer Discovery Protocol (LLDP)
DESC RIPT IO N
Note: For PoE models only.
The Power Via MDI TLV allows network management to advertise and discover the MDI
power support capabilities of the sending port on the remote device.
• Port Class
• MDI Supported
• MDI Enabled
• Pair Controllable
• PSE Power Pairs
• Power Class
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
> >
L L DP
Advanced Application > LLDP > LLDP-MED Configuration
DESC RIPT IO N
This displays the Switch's port number. Select * to configure all ports simultaneously.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select to enable LLDP-MED topology change traps on this port.
GS2220 Series User's Guide
L L DP- MED C o nfig ura tio n
334
link on the top navigation panel to
Sa ve
to display the screen as shown next.