D Simulation - HEIDENHAIN 548431-05 User Manual

7
7.10

3-D simulation

3-D simulation in Simulation submode
In the Simulation submode, you can test a program with the 3-D
simulation.
Activating 3-D simulation:
Select the 3-D simulation menu item
Deactivating 3-D simulation:
Select the 2-D simulation menu item
The following functions are identical to 2-D simulation:
Using the simulation
Further information:
3-D view
Further information:
Mid-program startup
Further information:
Page 546
Time calculation
Further information:
Saving contours
Further information:
Miscellaneous functions soft keys
This function can only be used if values have been
specified in the optional WHT and TOF parameters of
the tool holder function.
Further information:
Simulation of multiple contour groups
In 3-D simulation, only a single contour group is shown. If the
NC program includes multiple contour groups, you can use the soft
key to change between the contour groups.
554
"Using Simulation submode", Page 531
"3-D view", Page 541
"Start block in smart.Turn programs",
"Time calculation", Page 548
"Saving the contour", Page 549
Position a thread pattern on the surface
Display the workpiece edges
Switch to the next contour group
This soft key is only active if you are working
with multiple contour groups.
Display the tool holders
"Holder editor", Page 571
Graphic simulation | 3-D simulation
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017