HEIDENHAIN 548431-05 User Manual page 14

New functions of software 54843x-02
In the ICP editor submode, the Shift the datum miscellaneous
function was introduced, see "Datum shift", Page 434
In ICP contours, fit dimensions and inside threads can now be
calculated using an input form, see "Fits and internal threads",
Page 429
In the ICP editor submode, the miscellaneous functions
Duplicate in linear/Duplicate in circular series/Duplicate by mirroring
were introduced, see "Duplicating a contour section in linear
series", Page 435
The system time can be set using an input form, see "Displaying
operating times", Page 127
The parting cycle G859 was expanded by the parameters K, SD
and U, see "Cut off", Page 308
The ICP recess turning cycles allow defining an approach angle
and a departure angle, see "Radial ICP recess turning, finishing",
Page 299
With TURN PLUS you can now also create programs for
machining on the counter spindle and for multipoint tools,
see the smart.Turn and DIN Programming User's Manual
It is also possible to select a milling
contour in G797 Area milling,
see the smart.Turn and DIN Programming User's Manual
The parameter Y was added to G720,
see the smart.Turn and DIN Programming User's Manual
The parameters O and U were added to G860,
see the smart.Turn and DIN Programming User's Manual
14
Fundamentals | Software and features
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017