HEIDENHAIN 548431-05 User Manual page 513

ICP programming | Contours in the YZ plane
Horizontal lines in YZ plane
Programming a horizontal line:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
Z: Target point
Zi: Target point (incremental)
W: Target point (polar angle)
P: Target point (in polar coordinates)
L: Line length
F:
Further information:
ICP generates a G181 in smart.Turn mode of operation.
Line at angle in YZ plane
Programming a line at an angle:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
Y, Z: Target point
Yi, Zi: Target point (incremental)
W: Target point (polar angle)
P: Target point (in polar coordinates)
L: Line length
AN: Angle
ANn: Angle to the subsequent element
ANp: Angle to the previous element
F:
Further information:
ICP generates a G181 in smart.Turn mode of operation.
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
"Machining attributes", Page 418
"Machining attributes", Page 418
6
513