Reference Data And Nested Contours - HEIDENHAIN 548431-05 User Manual

6

Reference data and nested contours

When describing a milling contour or hole, you define the
reference plane. The reference plane is the position on which the
milling contour or the hole is created.
Frontface (C axis): The Z position (Reference dimension)
Surface (C axis): The X position (Reference diameter)
Frontface (Y axis): The Z position (Reference dimension)
Surface (Y axis): The X position (Reference diameter)
It is also possible to
Defining a slot in a rectangular pocket. Holes are drilled inside this
slot. You use the reference plane to specify the positions of these
elements.
ICP supports the selection of the reference plane. The following
reference data are loaded during selection of a reference plane.
Frontface: Reference dimension
Surface: Reference diameter
Frontface: Reference dimension, spindle angle, limit diameter
Surface: Reference diameter, spindle angle
Selecting a reference plane:
Select contour, figure, hole, pattern, single surface or polygon
Press the Select reference plane soft key
ICP displays the finished part and, if available, the
contours already defined
Use the soft keys (see table) to select the
reference dimension, reference diameter or
existing milling contour as reference plane
Confirm the reference plane
ICP loads the values of the reference plane as
reference data
Complete the reference data and describe the
contour, figure, hole, pattern, single surface or
polygon
Soft keys for nested contours
472
ICP programming | C-axis and Y-axis machining in smart.Turn mode of operation
nest milling contours and holes. Example:
Switch to the next contour of the same
reference plane
Switch to the previous contour of the same
reference plane
Switch to the next nested contour
Switch to the previous nested contour
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017