Introduction and fundamentals | Fundamentals
Workpiece datum
To machine a workpiece, it is easier to enter all input data with
respect to a zero point located on the workpiece. By programming
the zero point used in the workpiece drawing, you can take the
dimensions directly from the drawing, without further calculation
(dimensioning origin). This point is the workpiece datum. The
workpiece datum is designated with the letter W.
Units of measure
You can program the control either in the
The units of measurement listed in the table below apply to all
inputs and displays.
Dimensions
Coordinates
Lengths
Angle
Spindle speed
Cutting speed
Feed per revolution
Feed per minute
Acceleration
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
metric
or
inch
system.
Metric
Inches
mm
inch
mm
inch
Degrees
Degrees
rpm
rpm
m/min
ft/min
mm/rev
inch/rev
mm/min
inch/min
m/s
ft/s
2
2
1
55