Driven Tools; Tools In Different Quadrants - HEIDENHAIN 548431-05 User Manual

4

Driven tools

Driven tools are defined in the tool description
The driven tool can be operated with feed per revolution if the
tool spindle drive is equipped with a rotary encoder
If driven tools are used at a constant cutting speed, the spindle
speed is calculated from the tool diameter

Tools in different quadrants

Example
The principal tool carrier
(standard quadrant). An additional tool holder is behind the
workpiece.
When the control is configured, it is defined for each tool holder
whether the X dimensions and the direction of rotation of circular
arcs are mirrored. In the above-mentioned example the additional
tool holder is assigned the attribute mirrored.
If this method is used, all machining operations are programmed
as usual—regardless of which tool holder executes the operation.
The Simulation submode also shows all machining operations in
the standard quadrant.
The tools are also described and dimensioned for the
quadrant—even if they are inserted in the additional tool holder.
Mirroring does not become effective until the machining of the
workpiece, i.e. when the additional tool holder is executing the
machining operation.
118
of your lathe is in front of the workpiece
Machine mode of operation | Pocket table setup
standard
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017