Run Graphic Simulation Of Cycle - HEIDENHAIN MANUALPLUS 4110 Manual

Create the "Form roll" cycle program

Press the ICP cut radial
menu key
Enter the cycle parameters:

Starting point X: 62 mm

Starting point Z: 2 mm

Recessing width P: No entry
(The recessing width is derived from
the "cutting width" tool parameter.)

I oversize X: 0.2 mm

K oversize Z: 0.2 mm

ICP contour number N: 3
(For programming of the ICP contour,
see Page 11)

Distance DX to the subsequent
recess: No entry

Distance DZ to the subsequent
recess: No entry

Q number of recess cycles: 1

Tool number T: 10

Cutting speed S: 120 m/min

Feed rate per revolution F:
0.2 mm/rev
Assume the tool number and technology
data from the tool file.

Press the Input finished
soft key
Run a graphic simulation of the cycle
The tool-path simulation accounts for the exact geometry of the tool tip. Therefore, this
simulation is recommended for the recessing process.

Press the Graphics soft key
HEIDENHAIN MANUALplus 4110 Recess Machining Example 9.4