HEIDENHAIN 548431-05 User Manual page 698

10
Nonconvertible elements:
If the DIN program contains nonconvertible elements, the
corresponding NC block is saved as a comment. The word
Warning is inserted in front of this comment. Depending on
the situation, the nonconvertible command is taken into the
comment line, or the nonconvertible NC block follows the
comment.
Danger of collision!
Converted NC programs may have incorrectly converted
contents (machine-dependent) or nonconvertible contents.
Danger of collision during machining!
Adapt converted NC programs to the current control
Check the NC program using the verification graphics in the
Simulation submode
698
NOTICE
Tables and overviews | Compatibility in DIN programs
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017