Settings - HEIDENHAIN 548431-05 User Manual

7
7.9

Settings

General Settings
In Simulation submode, you can define general simulation
Settings.
Defining Settings:
Press the Miscellaneous functions soft key
Select the Misc menu item
Select the Settings menu item
The following settings are available:
Mark the machining area
Further information:
Activate the variable display
Further information:
C0 – Marking on workpiece/3D
Further information:
Page 553
Mark the machining area
In 2-D simulation, you can mark the following machining areas:
0: Off – No machining area will be marked
1: Line – The current cycle will be marked in blue
2: Area – The currently machined cycle, including the approach
and departure area will be marked with a blue frame
This setting is volatile.
Variables
Activate the variable display
In 2-D and 3-D simulation, you can display the variables defined in
the PROGRAM HEAD program section.
Further information: smart.Turn and DIN Programming User's
Manual
Activate the variable display
0: No – Variables are not displayed
1: Yes – Variables are displayed below the simulation window
552
"Mark the machining area", Page 552
"Variables", Page 552
"C0 – Marking on workpiece/3D",
Graphic simulation | Settings
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017