6
Contour direction (cycle programming)
The cutting direction during cycle programming depends on the
direction of the contour. If the contour is described in the –Z
direction, a tool with the orientation 1 must be used for longitudinal
machining. The cycle used determines whether machining is
transverse or longitudinal.
Further information:
If the contour is described in the –X direction, a transverse
machining cycle or a tool with the orientation 3 must be used.
ICP cut, longitudinal/transverse
machines the workpiece in the contour direction.
ICP finishing, longitudinal/transverse
the contour direction.
An ICP contour which was defined for a roughing
operation with the ICP cut longitudinal cycle cannot be
used for machining with the ICP cut transverse cycle.
Reverse the contour direction with the Turn contour
soft key.
Soft keys in the ICP editor submode – Main menu
438
"General tool parameters", Page 576
(roughing): The control
: The control finishes in
Invert the definition direction of the contour
ICP programming | Programming ICP contours
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017