HEIDENHAIN 548431-05 User Manual page 287

Teach-in | Recessing cycles
Radial recess turning, finishing
Select Recessing cycle
Select Recess turning
Select Radial recess turning
Press the Finishing run soft key
The cycle finishes the contour area defined by the Start point and
the End point contour.
Further information: "Recess turning", Page 279
With oversizes I, K, you define the material left
remaining after the finishing cycle.
Cycle parameters:
X, Z: Start point
X2, Z2: End point contour
I, K: Oversize blank X and Z
G47: Safety clearance
Further information:
T: Tool number – turret pocket number
G14: Tool change point
Further information:
ID: ID no.
S: Cutting speed or Constant speed
F: Feed per revolution
MT: M after T: M function that is executed after the tool call T
MFS: M at beginning: M function that is executed at the
beginning of the machining step
MFE: M at end: M function that is executed at the end of the
machining step
WP: No. of spindle – Displays which workpiece spindle is used
to execute the cycle (machine-dependent)
Main drive
Opposing spindle for rear-face machining
BW: Angle in the B axis (machine-dependent)
CW: Reverse the tool (machine-dependent)
HC: Shoe brake (machine-dependent)
DF: Miscellaneous function (machine-dependent)
Type of machining for technology database access:
Recess turning
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
"Safety clearance G47", Page 180
"Tool change point G14", Page 180
5
287