HEIDENHAIN 548431-05 User Manual page 301

Teach-in | Recessing cycles
Axial ICP recess turning, finishing
Select Recessing cycle
Select Recess turning
Select ICP-Recess turning transv.
Press the Finishing run soft key
The cycle finishes the contour area defined by the ICP contour. At
the end of the cycle, the tool returns to the Start point.
Further information: "Recess turning", Page 279
With workpiece-blank oversizes RI, RK, you define
the material to be machined during the finishing
cycle. For this purpose, enter the oversizes for recess
turning, finishing
With oversizes I, K, you define the material left
remaining after the finishing cycle
Cycle parameters:
X, Z: Start point
FK: No. of ICP finished part – name of contour to be machined
RB: Depth compens.
I, K: O-size X and Z
SX, SZ: Cutting limit in X and Z
Further information:
RI, RK: Oversize blank X and Z
T: Tool number – turret pocket number
G14: Tool change point
Further information:
ID: ID no.
S: Cutting speed or Constant speed
F: Feed per revolution
A: Start angle (default: opposite to recessing direction)
W: Depart.angle (default: opposite to recessing direction)
G47: Safety clearance
Further information:
MT: M after T: M function that is executed after the tool call T
MFS: M at beginning: M function that is executed at the
beginning of the machining step
MFE: M at end: M function that is executed at the end of the
machining step
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
"Cutting limits SX, SZ", Page 180
"Tool change point G14", Page 180
"Safety clearance G47", Page 180
5
301