Programming Teach-In Cycles - HEIDENHAIN 548431-05 User Manual

Machine mode of operation | Teach-in submode

Programming Teach-in cycles

When creating a new Teach-in program, you program each cycle in
the following sequence of actions
Save. The individual cycles form the cycle program.
You can change Teach-in programs by simply editing the necessary
cycle parameters, and delete or add cycles as required.
When you exit the Teach-in submode or switch off the machine,
the Teach-in program is kept. When you call an ICP cycle, the
control displays a soft key for switching to the ICP contour editor.
"ICP editor submode in Teach-in", Page 419
Further information:
DIN subprograms are programmed in the smart.Turn editor and
then integrated in a DIN cycle. You can use either the Edit DIN soft
key to go into the smart.Turn editor when you select the DIN cycle,
or the operating-mode key.
Soft keys
Switch to the
function
Renumber the block numbers of the cycles
Enter / edit the program description
Delete the selected cycle
Copy the cycle parameters into a buffer
memory
Example: Copy the parameters of the rough-
ing cycle to the finishing cycle
This soft key is available once you press the
Copy cycle soft key.
Insert copied data from the buffer
Change the cycle parameter or cycle mode.
The cycle type, however, cannot be
changed.
Insert a new cycle below the highlighted
block
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Enter – Simulate – Execute –
select cycle programs
4
141