HEIDENHAIN 548431-05 User Manual page 612

9
Settings for the simulation
Delta Z (115204)
[mm]: Horizontal extension of the graphic window
Simulation
Definition of the (default) workpiece blank size (115300): If no workpiece blank has been programmed in
DIN PLUS, the simulation will use the default workpiece blank
Outside diameter (115301)
[mm]
Length of the workpiece blank (115302)
[mm]
Right edge of the workpiece blank (115303)
[mm]
Inside diameter (115304)
[mm]
Settings for fixed cycles and units
Processing
General settings (602000)
Type of tool access (602001)
0: First from the NC program, then from the tool table
1: Only from the NC program
2: First from the NC program, then from the magazine
3: First from the NC program, then from the magazine, then from the tool table
Safety clearance, outside (SAR) (602005)
[mm]: Safety clearance to the workpiece blank, outside
Safety clearance, inside (SIR) (602006)
[mm]: Safety clearance to workpiece blank, inside
Safety clearance to the prepared workpiece, outside (SAT) (602007)
[mm]: Safety clearance to the prepared workpiece, outside
Safety clearance to the prepared workpiece, inside (SIT) (602008)
[mm]: Safety clearance to the prepared workpiece, inside
G14 for new units (602009): Default value for tool change position G14
No axis
0: Simultaneously
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
5: Only Y
612
Organization mode of operation | Parameters
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017