HEIDENHAIN 548431-05 User Manual page 688

10
Specifications
Ambient temperature
User functions
Configuration
Machine mode of operation
Teach-in submode
Program run submode
Setup functions
688
Tables and overviews | Technical information
Operation: 5 °C to 40 °C
Storage: -20 °C to +60 °C
Basic version: X and Z axis, spindle
Y axis (optional)
Driven tool (optional)
C axis (optional)
B axis (optional)
Digital current and speed control
Rear-face machining with the opposing spindle
(optional)
Manual slide movement through manual direction
keys or electronic handwheel
Graphic support for entering and running Teach-
in cycles without saving the machining steps in
alternation with manual machine operation
Thread reworking (thread repair) in a second
workpiece setup (optional)
Sequential linking of Teach-in cycles, where each
machining cycle is run immediately after input, or is
graphically simulated and subsequently saved.
All are possible in single-block and full-sequence
modes:
DINplus programs
smart.Turn programs (optional)
Teach-in programs (optional)
Setting the workpiece datum
Defining the tool change point
Defining the protection zone
Measurement of the tool by touch-off, touch probe,
or optical gauge
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017