Setting The Language; Performing The Reference Mark Search After Startup; User Interface - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Basic operation | Setting the language
6.6

Setting the language

The user interface language is English. You can change to another language, if
desired.
6.7

Performing the reference mark search after startup

If the reference mark search after unit start is active, then all of the
unit's functions will be disabled until the reference mark search has
been successfully completed.
Further information:
The reference mark search does not need to be performed for serial
encoders with EnDat interface, because the axes are automatically
homed.
If the reference mark search is active on the unit, then a wizard will ask you to
traverse the reference marks of the axes.
After logging in, follow the instructions of the wizard
The Reference symbol stops blinking upon successful completion of the
reference mark search
Further information:
Further information:
6.8

User interface

The unit is available in different versions, which are variously equipped.
The user interface and available functions may vary depending on the
version.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Tap Settings in the main menu
Tap User
The logged-in user is indicated by a check mark
Select the logged-in user
The language selected for the user is indicated by a national
flag in the Language drop-down list
Select the flag for the desired language from the Language
drop-down list
The user interface is displayed in the selected language
"Reference marks (Encoder)", Page 255
"Operating elements of the position display", Page 78
"Activating the reference mark search", Page 113
6
65