Table of Contents
Advertisement
# telnet 132.25.47.146
Return
User admin
Passwd
:Admin> switchName fcsw1
:Admin> switchName
fcsw1
:Admin>
______________________
When you telnet to the switch the next time, the prompt will
include the switch name, for example:
fcsw1:Admin>
6.5.2 Installing and Configuring the KGPSA PCI-to-Fibre Channel
Adapter Module
The following sections discuss KGPSA installation and configuration.
6.5.2.1 Installing the KGPSA PCI-to-Fibre Channel Adapter Module
To install the KGPSA-BC or KGPSA-CA PCI-to-Fibre Channel adapter
modules follow these steps. For more information, see the following
documentation:
•
KGPSA-BC PCI-to-Optical Fibre Channel Host Adapter User Guide
(AA-RF2JB-TE)
•
64-Bit PCI-to-Fibre Channel Host Bus Adapter User Guide
(AA-RKPDA-TE/173941-001)
_____________________
Static electricity can damage modules and electronic components.
We recommend using a grounded antistatic wrist strap and a
grounded work surface when handling modules.
1.
If necessary, install the mounting bracket on the KGPSA-BC module.
Place the mounting bracket tabs on the component side of the board.
Insert the screws from the solder side of the board.
2.
The KGPSA-BC should arrive with the gigabit link module (GLM)
installed. If not, close the GLM ejector mechanism. Then, align the
6–22 Using Fibre Channel Storage
Return
Return
Return
Return
Note
Caution
_______________________
_____________________
Advertisement
Table of Contents
