Table 5-1: Testing With The Show Config Display - Compaq AlphaServer 1000A Owner's Manual

Table 5–1: Testing with the show config Display
Step Action
1 Enter the show config
command to display the system
configuration.
2 Examine the PCI Bus or EISA
bus information in the display to
make sure the new option is
listed.
3 Verify the device name of the
new option.
4 Run a self-test on the option by
entering the test command
followed by its device name.
Example 5–1 shows the information that displays when you enter the show config
command.
Installing and Removing Components
Result
The system responds with a display
similar to Example 5–1.
If the option is not listed, see
"Troubleshooting Your System."
You must know the device name to
run diagnostic tests on the option.
Enter the show device command
to see the device name.
If the self-test passes, the system
displays the word OK (6) before it
displays the console prompt (>>>).
If the system displays a failure
message, see "Troubleshooting Your
System "
AlphaServer 1000A Rackmount Owner's Guide 5-13