Setup (Dhcp) - Agilent Technologies 1260 Infinity II User Manual

11
LAN Configuration
Dynamic Host Configuration Protocol (DHCP)

Setup (DHCP)

The DHCP functionality is available on all Agilent HPLC modules with on-board LAN
Interface or LAN Interface Card G1369C, and "B"-firmware (B.06.40 or above) or modules
with "D"-firmware. All modules should use latest firmware from the same set.
1 Note the MAC address of the LAN interface (provided with G1369C LAN
2 Set the Configuration Switch to DHCP either on the G1369C LAN Interface
Table 19
SW 4
ON
232
Interface Card or Main Board). This MAC address is on a label on the card
or at the rear of the main board, e.g. 0030d3177321.
On the Local Controller the MAC address can be found under Details in the
LAN section.
Figure 30 LAN Setting on Instant Pilot
Card or the main board of above mentioned modules.
G1369C LAN Interface Card (configuration switch on the card)
SW 5 SW 6
OFF OFF
SW 7 SW 8 Initialization Mode
OFF OFF DHCP
1260 Infinity II Flexible Pump User Manual