Initialization Mode Selection - Agilent Technologies 1260 Infinity II User Manual

Initialization Mode Selection

The following initialization (init) modes are selectable:
Table 17 Initialization Mode Switches
1
Requires firmware B.06.40 or above. Modules without LAN on board, see G1369C LAN Interface Card
Using Stored
When initialization mode Using Stored is selected, the parameters are taken
from the non-volatile memory of the module. The TCP/IP connection will be
established using these parameters. The parameters were configured
previously by one of the described methods.
Figure 27
1260 Infinity II Flexible Pump User Manual
SW 6 SW 7
OFF ON
OFF ON
ON OFF
Using Stored (Principle)

Initialization Mode Selection

SW 8 Init Mode
OFF Using Stored
ON Using Default
OFF
1
DHCP
11
LAN Configuration
229