Link Configuration Selection - Agilent Technologies 1260 Infinity II User Manual

11
LAN Configuration

Link Configuration Selection

Link Configuration Selection

The LAN interface supports 10 or 100 Mbps operation in full- or half-duplex
modes. In most cases, full-duplex is supported when the connecting network
device - such as a network switch or hub - supports IEEE 802.3u
auto-negotiation specifications.
When connecting to network devices that do not support auto-negotiation, the
LAN interface will configure itself for 10- or 100-Mbps half-duplex operation.
For example, when connected to a non-negotiating 10-Mbps hub, the LAN
interface will be automatically set to operate at 10-Mbps half-duplex.
If the module is not able to connect to the network through auto-negotiation,
you can manually set the link operating mode using link configuration
switches on the module.
Table 21 Link Configuration Switches
234
SW 3 SW 4 SW 5
OFF - -
ON OFF OFF
ON OFF ON
ON ON OFF
ON ON ON
Link Configuration
speed and duplex mode determined by
auto-negotiation
manually set to 10 Mbps, half-duplex
manually set to 10 Mbps, full-duplex
manually set to 100 Mbps, half-duplex
manually set to 100 Mbps, full-duplex
1260 Infinity II Flexible Pump User Manual